Holes Are Loose In Door Hinge

After time the weight of the door will pull on the hinge and cause the door not to hang straight.

Holes are loose in door hinge.

Screw through the middle hole and redrill the top screw hole at a slight angle so the screw hits solid wood. How to tighten stripped hinge screws. Fix it the right way not the wrong way. Screws straight through the two holes toward the center of the door.

I see this often on kitchen cabinet hinges and doors regular door hinges and areas that get worked or moved a lot. If you have a centering hinge drill use the hinge as a template and the finish repair will be better than new and last for years. Eventually the holes become so large that the screws can t stay tight. Door the everbilt 3 1 2 in.

If the door has a large hinge with four screw holes just drive 3 in. Open the door wide and insert a wedge under the bottom outside corner to level it. These hinges are made of steel for durability. The small screws used to secure kitchen cabinet door hinges to the face frames of cabinets often work their way loose over time.

A quick convenient cure can be found just inside one of the cabinets. However if the hinge has only three holes add a 3 in. The everbilt 3 1 2 in. If you have a loose hinge and you can t tighten it because the screws just spin in place the screw holes are probably stripped.

It kept backing out on its own. The wrong way is a temporary fix not cool. A loose butt hinge will cause a door to hang crooked and stick. Unless they re tightened immediately the screws will enlarge and strip the holes until it s impossible to tighten them.

Another hint is to use a long screw in one of the holes in the top most hinge long enough to penetrate the stud. But when hinge screws are left loose for a long time the constant movement of the hinge plate and screws enlarges the screw holes. You can see in the image below the loose screw was on my door lock striker. Sometimes retightening the hinge screws is all it takes to fix the problem.

If the hinge screws have been loose for only a short time you may need to tighten them with a screwdriver. But if the screws can t be tightened because the holes are stripped try this.